PDA

View Full Version : GT500 on the Dyno


03ebz06
04-22-2012, 10:35 PM
Got some bad belt slip to fix next week, then going to address the traction issues.

<iframe width="420" height="315" src="http://www.youtube.com/embed/KwRN0gryOZk" frameborder="0" allowfullscreen></iframe>

1998ta__1991rs
04-22-2012, 10:54 PM
tell travis he needs to clean the shop

03ebz06
04-22-2012, 10:59 PM
lol. I think he just did.

Carlrx7
04-23-2012, 12:32 AM
scary! what numbers did it make? what do you think it will make after fixing the belt slip?

03ebz06
04-23-2012, 05:35 AM
scary! what numbers did it make? what do you think it will make after fixing the belt slip?

It did mid 6xx hp and low 7xx tq. I cant really guess with the spinning and slipping but would be mid 700's based off the torque numbers that run if the belt had not crapped clear out at 5k rpm.

jmd
04-23-2012, 06:09 AM
what have you done to the car?

schardbody
04-23-2012, 06:39 AM
about the same power my buddy makes with just minor bolt ons, pulley and tune. Them cars are ridiculous.

03ebz06
04-23-2012, 10:55 AM
It's a TVS swap with bolt ons.

schardbody
04-23-2012, 01:31 PM
How much boost? I think he's at 13psi but I could be totally wrong. He made 640 with air intake mufflers pulley and tune.

03ebz06
04-23-2012, 08:44 PM
How much boost? I think he's at 13psi but I could be totally wrong. He made 640 with air intake mufflers pulley and tune.

I'm somewhere between 20 and 22psi. If he is on the stock SC he should be around 550 but could be over 600 if it's ported.

schardbody
04-23-2012, 09:24 PM
you are right, i just asked him and he said 540, and blower is untouched. only mods are what was mentioned, it was tuned by amazon...

its his daily so he doesnt race..

FRDnemesis
04-26-2012, 07:15 PM
What was causing it to smoke so much?

Qwik_Sn95
04-26-2012, 07:21 PM
That was tire smoke on the dyno