How hard would it be to do motor mounts on the 99 MGT?

[04ctd]

just thinking about it.

that car has had a rough life.

we did a new tranny mount when Robert did the tranny.

[04ctd]

Breaker One-9

anyone got their ears on?

[1iron]

WTF is an MGT?

[BAD BOB]

mustang GT

[MonteC]

Breaker One-9

anyone got their ears on?


10-4 good buddy. unfortunately i have no clue.

[LXtasy]

are they different than other vehicles? like take out the bolt from the motor mount to the frame mount and lift/support the motor up and undo some bolts and slide new one in?

From my experience when changing out motor mounts when motor still in vehicle is to have a cherry pick help hold the side up you are working on. As you may need to lift it more alittle at a time as you slide the mount out.

[04ctd]

are they different than other vehicles? .

i hope not,

but i asked about valve seals in the 4.6, and they said to pull the heads.

okay, it's as simple as regular mounts....who can i borrow a cherry picker from?

[MonteC]

i hope not,

but i asked about valve seals in the 4.6, and they said to pull the heads.

okay, it's as simple as regular mounts....who can i borrow a cherry picker from?

Ive got you covered john. Just let me know where i need to drop it off.

[04ctd]

Ive got you covered john. Just let me know where i need to drop it off.

my house

whenever you have time to help do it :)

[04ctd]

oh my goodness.
basically took 3 days:
-get it up in the air
-figure out HOW to get them out & what tools to buy
-buy tools, get them out, then back in.


WHAT a crazy job, had to remove:
-starter
-one ignition coil
-H pipe
-electric plugs on intake.

had to buy $70 worth of tools.
had to buy all new bolts, because of the angle, i stripped them trying to use 12pt sockets. had to switch to 6 points.

it took until ~2am Wed nite to get it done.