LS tech assistance needed

[toybreaker]

I need to take some measurements off of a LS based intake manifold. I want to see if i can fab up an adaptor plate for the Eaton S/c I have to bolt up to a 5.3 5.7 6.0 6.2 etc... with or without my Intercooler. A stock plastic one will work

[Derek]

I got one laying around.

[BigdaddyDupree]

ill test the prototype like we talked about!

[Carlrx7]

Kenne Bell > Eaton

[toybreaker]

Kenne Bell > Eaton

And?

[bwelch]

I have a truck intake

[toybreaker]

Doesn't matter what type as long as the port configuration is roughly the same. I'll come get it just let me know where / when.
thanks for the help!

[BAD BOB]

i got a few also

[toybreaker]

Nyone with an LS manifold laying around going to Sonic tonight?
if so let me know six 1 nine 4 one seven 1667

[toybreaker]

Thanks for the loan Bob. I'll have it back to you soon......

Once i get the lower intake fabbed and get the blower base roughed I will need to position the blower on a mock motor for pulley alignment.... anyone?

[1998ta__1991rs]

Thanks for the loan Bob. I'll have it back to you soon......

Once i get the lower intake fabbed and get the blower base roughed I will need to position the blower on a mock motor for pulley alignment.... anyone?

ive got a junked aluminum block you can use, no heads though

[BAD BOB]

i got a set of stock heads that i may be able to let borrow

[toybreaker]

Awesome. when i am ready I'll let you all know!

[toybreaker]

After Starting to fab this thing up I don't think anyone would be willing to pay the materials cost let alone machine time necessary. I am going to make an upper "blower"
manifold to go on a 5.0 EFI lower manifold and plumb it for water/meth injection.
Be a whole lot easierr and cheaper.