06 TBSS MPH Stall Converters
 

OK, saw a video the other day in a TBSS that did a launch, the speedo stayed at 0mph until he let off.

Is this still an issue? or has there been a patch in HPT or a workaround?

was going to slip a I6 converter in there, but not if the speedo gets fubard. The way I drive it will always read 0! lol

Should not be an issue.

I know way back when I put a converter in mine it did tg e same thing. But only from a dead stop. I would think by now that there would be a way around it in the computer

As far as I know there is still no fix.

Still no fix. I spent an hour reading an old revived thread yesterday that ended with zero results. Lots of things tried(way beyond my comprehension with programming ) all to no avail.

Are you thinkin about stalling yours?

I have a circle d 3200 in mine if u want to experience it.

anyone tried just unpluging the input sensor and sending the output sensor's signal to the input sensors pin? that way they would always match.

-Carl

What causes this?

have to take you up on that off soon!

They tried it all man. Including running a separate TCM with custom OS just to monitor output shaft speed and do calcs for mph and outputting to speedo. Wouldn't work

Anytime man. I'm awd though. Changes shit off the line.

Some good but disappointing reading.

http://www.tbssowners.com/forums/showthread.php?t=13660