Need help removing pinion bearing stock 10 bolt
 

Okay, I can't figure out how to get the old pinion bearing out to put the new one in. I have the driveshaft dropped out and the seal off, but can't get the bearing to move. Is there a special tool or trick to getting it out? Trying to avoid dropping and disassembling the rear at all cost. Thanks in advance for any help!

Pinion bearings are usually an interference fit to the pinion shaft. The axles and carrier will have to come out so you can drive the pinion out the back of the housing.

gonna have to pull it apart, pull axles, carrier, drive pinion out of bearing..............

Yeah, talked to MonteC, found that out. This project will have to wait until next weekend lol