Brad, flowed a set of as cast Trick Flow twisted Wedge heads last night and my numbers are exactly the same as what everyone says online.
at .500 they were done, 250 cfm, well at .600 it was 253 but it was over at that point
I'm very excited after a completely frustrating week of breaking shit and chasing Texas Speeds numbers. I must have had the head on the flow bench 20 times trying to get my numbers over the 280 mark In my first post with a set of LS 317 heads. There was no way I could take out the same amount of metal of the Texas Speed head and charge what I do. I would have really been happy to hit 290 cfm @ .600 with a much smaller port but the results are in. IMO, I like the Texas Speed Head and I'm sure AI's is really good too but If your going to run the TS head I would only put it on a stroker
__________________
|