Carolina Horsepower - View Single Post

98Camarod · 03-22-2015, 07:47 PM

I got some stuff done. I got the brake lines all tightened, made brackets for the rear end and all of the brake lines are mounted and tight. I do have to figure out the push rod for the wilwood master cylinder.

I also got some of the cold side done. I got from the firewall to behind the front seat. I have two 90's to weld on there and the vband and that will be done. Then I can mount the intercooler and then run the piece to the engine.

03-22-2015, 07:47 PM	#31
98Camarod Senior Member Join Date: Mar 2009 Location: Summerville, SC Posts: 1,525	I got some stuff done. I got the brake lines all tightened, made brackets for the rear end and all of the brake lines are mounted and tight. I do have to figure out the push rod for the wilwood master cylinder. I also got some of the cold side done. I got from the firewall to behind the front seat. I have two 90's to weld on there and the vband and that will be done. Then I can mount the intercooler and then run the piece to the engine.