id like to see it without the top hat on it personally. it looks like bar/fin core..
its only dropping intake temps so much regardless...
lets say u started with a 60deg intake temp... id assume with this setup and a ice/water/exchanger system.. even under higher loads(short burts) id assume ideal intake temps would be in the low 100/120deg... ideally it would be in the 70/80 at the track.
you would ice the hat down in the pits.. and do a pre ice circulation in stagingl anes.. just before u roll into the box.. ur pump the rest and apply the rest of the ice.. with that in mind you would be mid 90deg temps..
if you are running a remote mount/rear mount the temps will be lower if it is a front mount turbo temps will be roughly the same..
i would personally run a honda shorty aluminum raditor
http://www.full-race.com/catalog/pro...roducts_id=481
with a meziere water/fluid pump
and some type of a ice /water chest with like an-12 lines