FS White 08 Base C6 Forged 12:1 416ci Built By LG Motorsports 29k Firm

03ebz06 · 07-23-2013, 06:31 PM

For Sale 29,000 Firm. Very good condition.

VIN# 1G1YY25W685128920

Have receipts totaling over 16k(Added wrong the first time) from the previous owner.

http://forums.corvetteforum.com/c6-t...completed.html

http://forums.corvetteforum.com/c6-c...t-numbers.html

http://forums.corvetteforum.com/c6-c...pdate-pic.html

White with black leather interior. Built by LG Motorsports in Texas. The entire build was done at one time and the build was focused to be a pump gas driver with high HP and reasonable daily driveability. 47,540 miles, and I still drive it so it will go up. Roughly 9,000 miles on complete build

The previous owner had the work done and this is part of his ad.

Partial build list as follows. ..

LG Motorsports built (NEW not rebuilt LS3 Balanced and Blueprinted Stroker 416ci high Compression 12:1 built and tuned for 93 octane)
LG Motorsports LS3 heads (ported and polished)
Callies forged rotating assembly
Diamond forged pistons
LG Motorsports G6X3 Cam package (very agressive cam / dual valve springs built valvetrain)
Fast LSXR 102mm intake manifold
Nick Williams 102mm throttlebody
LG Motorsports Carbon Fiber Intake
LG Motorsports Super Pro long tube headers (1" 7/8 runners stainless steel and jethot coated)
LG Motorsports GT-4 3'' full exhaust
RPM stage III rear diff 4.10 gear ratio.
RPS Billet twin carbon clutch system and aluminium flywheel
LG Motorsports remote clutch bleeder system LG Motorsports
Tune Final numbers for the power output were a very respectable 580rwhp and 540ftlbs of TQ (650-bhp).

I have since added a Snow meth kit so It isn't so picky with its gas. It only uses a 300hp or 500hp nozzle(have both) set at almost WOT so it last a very long time. It's usually close to full every time I check it.

It has a few imperfections that would reflect the mileage/year. There is a very small spider web crack in the paint on the nose. It is barely noticeable. It has a small scratch in the front fender. Again, not that noticeable. The transparent roof has some crazing that can only be seen from the inside. The headlights have this as well. The factory split spokes will need new rear tires. I have decent NT05R's on the Speedlines and that's what I am currently running on the rear. They are just plasti dipped.

The car is loud and drones at low rpms. Sounds like hell exploding when you put your foot in it. Children will cry!

Has 2 removable tops. White and Transparent.
Has 2 sets of wheels. Factory split spoke and OEM Z06 Speedline wheels.
Also have a Z06 front bumper/nose to go with it.

I just had a new TC button installed. The last one was stuck on but I took it to the track anyway. With a 2.0 60' it ran 11.20@130 in 97 degree heat after driving an hour and a half to the track. Best trap was 132. The TC was intrusive even into 3rd gear.

A video
C6 Corvette LS3 418 12:1 G6X3 LG-GT4 Idle and 50-130mph run. - YouTube

A pullied ZR1 comparison video
Pullied ZR1 vs 418ci LS3 - YouTube

Title in hand

Car is in Columbia South Carolina

AverageJoe · 07-23-2013, 06:44 PM

94zson · 07-23-2013, 07:26 PM

That would be sweet since I am now a college faculty instructor!

03ebz06 · 07-23-2013, 07:39 PM

Yea, I don't like the gold under the hood either. I didn't do it. It does keep me from having to wear it around my neck though.

slowgreen99 · 07-23-2013, 07:41 PM

Interested in trades? Extremely competetive Ultimate Street fox body nitrous car...

03ebz06 · 07-23-2013, 08:00 PM

Quote:

Originally Posted by slowgreen99

Interested in trades? Extremely competetive Ultimate Street fox body nitrous car...

PM sent

ForceFed4g63 · 07-23-2013, 08:10 PM

Oh my...

Red99T/A · 07-23-2013, 08:23 PM

Quote:

Originally Posted by slowgreen99

Interested in trades? Extremely competetive Ultimate Street fox body nitrous car...

uh oh....

blkscls1z · 07-23-2013, 09:17 PM

Good luck with the sale John. Hopefully you can make Brandon a Base Model owner!

slowgreen99 · 07-23-2013, 09:43 PM

Haha, you know I don't have anything worth trading for that car! I was asking for a friend

NesbittRacing1 · 07-23-2013, 11:22 PM

No he was asking for me i just don't Get on here that often so i had Brandon ask

07-23-2013, 06:31 PM	#1
03ebz06 Senior Member Join Date: Nov 2007 Location: Irmo SC Posts: 120	FS White 08 Base C6 Forged 12:1 416ci Built By LG Motorsports 29k Firm For Sale 29,000 Firm. Very good condition. VIN# 1G1YY25W685128920 Have receipts totaling over 16k(Added wrong the first time) from the previous owner. http://forums.corvetteforum.com/c6-t...completed.html http://forums.corvetteforum.com/c6-c...t-numbers.html http://forums.corvetteforum.com/c6-c...pdate-pic.html White with black leather interior. Built by LG Motorsports in Texas. The entire build was done at one time and the build was focused to be a pump gas driver with high HP and reasonable daily driveability. 47,540 miles, and I still drive it so it will go up. Roughly 9,000 miles on complete build The previous owner had the work done and this is part of his ad. Partial build list as follows. .. LG Motorsports built (NEW not rebuilt LS3 Balanced and Blueprinted Stroker 416ci high Compression 12:1 built and tuned for 93 octane) LG Motorsports LS3 heads (ported and polished) Callies forged rotating assembly Diamond forged pistons LG Motorsports G6X3 Cam package (very agressive cam / dual valve springs built valvetrain) Fast LSXR 102mm intake manifold Nick Williams 102mm throttlebody LG Motorsports Carbon Fiber Intake LG Motorsports Super Pro long tube headers (1" 7/8 runners stainless steel and jethot coated) LG Motorsports GT-4 3'' full exhaust RPM stage III rear diff 4.10 gear ratio. RPS Billet twin carbon clutch system and aluminium flywheel LG Motorsports remote clutch bleeder system LG Motorsports Tune Final numbers for the power output were a very respectable 580rwhp and 540ftlbs of TQ (650-bhp). I have since added a Snow meth kit so It isn't so picky with its gas. It only uses a 300hp or 500hp nozzle(have both) set at almost WOT so it last a very long time. It's usually close to full every time I check it. It has a few imperfections that would reflect the mileage/year. There is a very small spider web crack in the paint on the nose. It is barely noticeable. It has a small scratch in the front fender. Again, not that noticeable. The transparent roof has some crazing that can only be seen from the inside. The headlights have this as well. The factory split spokes will need new rear tires. I have decent NT05R's on the Speedlines and that's what I am currently running on the rear. They are just plasti dipped. The car is loud and drones at low rpms. Sounds like hell exploding when you put your foot in it. Children will cry! Has 2 removable tops. White and Transparent. Has 2 sets of wheels. Factory split spoke and OEM Z06 Speedline wheels. Also have a Z06 front bumper/nose to go with it. I just had a new TC button installed. The last one was stuck on but I took it to the track anyway. With a 2.0 60' it ran 11.20@130 in 97 degree heat after driving an hour and a half to the track. Best trap was 132. The TC was intrusive even into 3rd gear. A video C6 Corvette LS3 418 12:1 G6X3 LG-GT4 Idle and 50-130mph run. - YouTube A pullied ZR1 comparison video Pullied ZR1 vs 418ci LS3 - YouTube Title in hand Car is in Columbia South Carolina Last edited by 03ebz06; 07-23-2013 at 07:35 PM.

07-23-2013, 07:26 PM	#3
94zson Senior Member Join Date: Dec 2008 Location: Ladson Posts: 632	That would be sweet since I am now a college faculty instructor! __________________ 01 Z28

07-23-2013, 07:41 PM	#5
slowgreen99 Senior Member Join Date: Jan 2008 Location: Summerville Posts: 7,740	Interested in trades? Extremely competetive Ultimate Street fox body nitrous car... __________________ M.R.E. Bad Bob Motorsports

07-23-2013, 09:17 PM	#9
blkscls1z Senior Member Join Date: Jun 2008 Location: Between Goose Creek & Moncks Corner Posts: 2,310	Good luck with the sale John. Hopefully you can make Brandon a Base Model owner! __________________

07-23-2013, 09:43 PM	#10
slowgreen99 Senior Member Join Date: Jan 2008 Location: Summerville Posts: 7,740	Haha, you know I don't have anything worth trading for that car! I was asking for a friend __________________ M.R.E. Bad Bob Motorsports

07-23-2013, 07:39 PM	#4
03ebz06 Senior Member Join Date: Nov 2007 Location: Irmo SC Posts: 120	Yea, I don't like the gold under the hood either. I didn't do it. It does keep me from having to wear it around my neck though.

07-23-2013, 08:10 PM	#7
ForceFed4g63 Senior Member Join Date: Oct 2009 Location: Aiken Posts: 7,002	Oh my...

07-23-2013, 11:22 PM	#11
NesbittRacing1 Senior Member Join Date: Dec 2011 Location: georgetown, sc Posts: 456	No he was asking for me i just don't Get on here that often so i had Brandon ask