Ford DOHC 304SS Coolant Crossover Tube Caps....

98mark8lsc · 01-29-2011, 12:18 AM

Any of you local DOHC guys interested in these?

I've been making and selling them on the Lincoln Mark VIII forums, and figured I'd open up the market for them a little bit.

I make them from 304 stainless steel on a lathe at work. My design incorporates an 18mm CNC-milled hex into the top of it to facilitate using a wrench to remove and install it, rather than the stupid little square hole that sucks.

I've been selling them for $40 shipped, but if anyone local wants one, we can forego the $5 shipping cost

Here's some pictures of one of them installed in a wrinkle black powdercoated crossover tube....

toybreaker · 01-01-2012, 03:05 PM

Now that Jay doesn't have access to the CNC mill... I am continuing to make and sell these on the mustang MB's. pm me If you are interested.

MGC · 02-25-2012, 01:51 PM

I signed up here to PM you, but can't, I need one of those. Thanks.

01-29-2011, 12:18 AM	#1
98mark8lsc Member Join Date: Mar 2010 Location: Summerville, SC Posts: 30	Ford DOHC 304SS Coolant Crossover Tube Caps.... Any of you local DOHC guys interested in these? I've been making and selling them on the Lincoln Mark VIII forums, and figured I'd open up the market for them a little bit. I make them from 304 stainless steel on a lathe at work. My design incorporates an 18mm CNC-milled hex into the top of it to facilitate using a wrench to remove and install it, rather than the stupid little square hole that sucks. I've been selling them for $40 shipped, but if anyone local wants one, we can forego the $5 shipping cost Here's some pictures of one of them installed in a wrinkle black powdercoated crossover tube.... __________________ -98 Mark VIII LSC - Blk/Blk - 101k - 18x9/10 Black Chrome FR500's, 2004 Cobra brakes, 3000 stall, 3.73's, Trac-Loc, Xcalibrator 2, K&N cone w/ custom CAI, 2.5" Flowmaster exh, NGK Iridiums, 93 driveshaft, BEC stage 5 shift kit, Pioneer DEH-P980BT, JL Audio 12W7, 1000/1, 300/4, XR comp's, 3% tint, Ray switch -97 Mark VIII Base - Wht/Blk - 151k - $900 car!

01-01-2012, 03:05 PM	#2
toybreaker Senior Member Join Date: Sep 2009 Location: Piti, Guam Posts: 203	Now that Jay doesn't have access to the CNC mill... I am continuing to make and sell these on the mustang MB's. pm me If you are interested. __________________ I am too good for something! I set a very bad example!

02-25-2012, 01:51 PM	#3
MGC Junior Member Join Date: Feb 2012 Posts: 1	I signed up here to PM you, but can't, I need one of those. Thanks.